Vendor: Cisco Exam Code: 100-105 Exam Name: Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0) Version: DemoDEMO

QUESTION 1 Refer to the exhibit. If the resume command is entered after the sequence that is shown in the exhibit, which router prompt will be displayed? A. Router1> B. Router1# C. Router2> D. Router2# Correct Answer: C

QUESTION 2 The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 was issued on a router. No routing protocols or other static routes are configured on the router. Which statement is true about this command? A. The interface with IP address 192.168.10.2 is on this router. B. The command sets a gateway of last resort for the router. C. Packets that are destined for host 192.168.100.160 will be sent to 192.168.10.2. D. The command creates a static route for all IP traffic with the source address 192.168.100.160. Correct Answer: C

QUESTION 3 Some routers have been configured with default cisco 200-125 routes. What are some of the advantages of using default routes? (Choose two) A. They establish routes that will never go down. B. They keep routing tables small. C. They require a great deal of CPU power. D. They allow connectivity to remote networks that are not in the routing table E. They direct traffic from the internet into corporate networks. Correct Answer: BD

QUESTION 4 Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.) Router(config)# router ospf 1A. All OSPF routers in an area must have the same process ID. B. Only one process number can be used on the same router. C. Different process identifiers can be used to run multiple OSPF processes D. The process number can be any number from 1 to 65,535. E. Hello packets are sent to each neighbor to determine the processor identifier. Correct Answer: CD

QUESTION 5 Which statements are TRUE regarding cisco 400-251 Internet Protocol version 6 (IPv6) addresses? (Choose three.) A. An IPv6 address is divided into eight 16-bit groups. B. A double colon (::) can only be used once in a single IPv6 address. C. IPv6 addresses are 196 bits in length. D. Leading zeros cannot be omitted in an IPv6 address. E. Groups with a value of 0 can be represented with a single 0 in IPv6 address. Correct Answer: ABE

QUESTION 6 Which two 700-070 dumps of these statements are true of IPv6 address representation? (Choose two.) A. There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast. B. A single interface may be assigned multiple IPv6 addresses of any type. C. Every IPv6 interface contains at least one loopback address. D. The first 64 bits represent the dynamically created interface ID. E. Leading zeros in an IPv6 16 bit hexadecimal field are mandatory. Correct Answer: BC

QUESTION 7 OSPF is configured using default classful addressing. 700-172 dumps With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be learned by OSPF? A. 2 B. 3C. 4 D. 5 E. 6 F. 7 Correct Answer: C

QUESTION 8 Refer to the exhibit. Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. 600-512 dumps How will the default route configured on R1 affect the operation of R2? A. Any packet destined for a network that is not directly connected to router R2 will be dropped immediately. B. Any packet destined for a network that is not referenced in the routing table of router R2 will be directed to R1. R1 will then send that packet back to R2 and a routing loop will occur. C. Any packet destined for a network that is not directly connected to router R1 will be dropped. D. The networks directly connected to router R2 will not be able to communicate with the 172.16.100.0, 172.16.100.128, and 172.16.100.64 subnetworks. E. Any packet destined for a network that is not directly connected to router R2 will be dropped immediately because of the lack 600-510 dumps of a gateway on R1. Correct Answer: B

QUESTION 9 ROUTER# show ip route 192.168.12.0/24 is variably subnetted, 9 subnets, 3 masks C 192.168.12.64 /28 is directly connected, Loopback1 C 192.168.12.32 /28 is directly connected, Ethernet0 C 192.168.12.48 /28 is directly connected, Loopback0 O 192.168.12.236 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0C 192.168.12.232 /30 is directly connected, Serial0 O 192.168.12.245 /30 [110/782] via 192.168.12.233, 00:35:36, Serial0 O 192.168.12.240 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0 O 192.168.12.253 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0 O 192.168.12.249 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0 O 192.168.12.240/30 [110/128] via 192.168.12.233, 00:35:36, Serial 0 To what does the 128 refer to in 600-509 dumps the router output above? A. OSPF cost B. OSPF priority C. OSPF hop count D. OSPF ID number E. OSPF administrative distance Correct Answer: A

Error displaying the error page: Application Instantiation Error: Failed to start the session because headers have already been sent by "C:\Inetpub\vhosts\sideradiko-papadopoulos.gr\httpdocs\includes\framework.php" at line 116.